Add Router IOS Image in GNS3
Yaser Rahmati | یاسر رحمتی
Last updated
Yaser Rahmati | یاسر رحمتی
Last updated
After installing GNS3, you need to add router IOS image in GNS3. To do so, you need to perform the following steps:
In the GNS3 console, click Edit and select Preferences to open the Preferences window. Click Next to add a new router IOS image in GNS3, as shown in the following figure.
In the IOS image page, select the New Image radio button, click Browse and select the router IOS image that you want to add in GNS3. In this case, e will use Cisco router c2691 IOS image. Click Next to proceed, as shown in the following figure.
In the Name and platform window, specify the name and platform for the IOS image and then click Next as shown in the following figure.
In the Memory page, set the desired Default RAM size and then click Next as shown in the following figure.
In the Network adapters page, ensure that slot 0 is already listed and selected. Select the additional slots, if required, and then click Next as shown in the following figure.
In the WIC modules page, select the WIC modules to add additional modules as per your requirement, and then click Next as shown in the following figure.
On the Idle-pc page, click Finish and then click OK to close the Preferences window.
In the GNS3 console, you can see that c2691 router is added. Drag it to the work view area as shown in the following figure. Right-click on the added router and then select Start to start it.
Open the console of the router as shown in the following figure.
